Description

EIBOS Cold Build Plate Krios — Symmetrical, Double-Sided Plate for Snapmaker U1

The EIBOS Krios is a double-sided cold build plate for the Snapmaker U1. The nozzle wipe zones are laid out symmetrically, so there’s no wrong way to install it. It also grips PLA from 40°C and PETG from 55°C without glue, which means lower bed temperatures, less warping on large flat prints, and one less prep step before every job.

On a four-toolhead printer running multi-colour and multi-material jobs, a plate that’s always the right way round and always ready to print keeps your workflow simple.

Symmetrical Design — No Wrong Way Round

Many build plates have a front and back, and fitting one the wrong way puts the nozzle wipe zone in the wrong place. Krios has four nozzle wipe zones in a fully symmetrical layout, so the zone is always in the correct position whichever way you place it. Swap plates quickly without checking orientation.

Strong Adhesion at Lower Temperatures

The surface grips PLA starting at 40°C and PETG at 55°C. Cooler beds reduce the thermal stress that causes warping and corner lift on large flat prints, and they shorten heat-up time between jobs. No glue is needed for these materials.

9-Layer Construction

A high-hardness, high-magnetism spring steel base carries a special coating formula. The microporous surface layer bonds with filament without needing high bed temperatures, and impact-resistant middle layers protect the plate against accidental nozzle collisions.

Effortless Print Removal

Let the plate cool, then flex it and prints release cleanly. Most prints come off without a scraper, which protects both the part and the surface.

Double-Sided

Both sides carry the same coating and performance. When one side wears, flip the plate over for a fresh surface and extend its overall life.

Easy to Clean

Wipe the plate with clean water to restore adhesion. No special solvents are needed.

Do not use isopropyl alcohol (IPA), acetone, or other organic solvents. They will damage the coating.

Compatibility

Snapmaker U1

This plate is made specifically for the Snapmaker U1 and is not interchangeable with plates for other Snapmaker models or other brands.

Specifications

Type: Double-sided cold build plate, 9-layer spring steel construction
Surface: Microporous coating, same on both sides
Adhesion: PLA from 40°C, PETG from 55°C, no glue needed
Nozzle wipe zones: 4, fully symmetrical
Cleaning: Water only, no IPA or acetone
Compatibility: Snapmaker U1