Description

IckySticky Brush On Electrical Tape — Liquid Insulation You Paint On

IckySticky Brush On Electrical Tape is a fast-drying liquid rubber coating that replaces traditional electrical tape for sealing, insulating, and protecting electrical connections. Brush it onto any wire, terminal, or connection and it dries to a flexible, waterproof, UV-resistant rubber coating that conforms to any shape — including tight spaces, irregular surfaces, and hard-to-reach joints where wrapping tape is impractical or impossible.

For 3D printer owners, RC builders, and electronics hobbyists, this is the clean, permanent alternative to messy tape wraps on solder joints, wire splices, and exposed connections.

Why Brush On Instead of Tape?

Traditional Electrical Tape

Unravels over time. Leaves sticky residue. Doesn’t conform to irregular shapes. Fails in heat and UV. Can’t reach tight spaces. Looks messy on small connections.

Brush On Electrical Tape

Paints on and dries to a permanent flexible rubber coating. Conforms to any shape including terminals, splices, and irregular joints. Waterproof, UV resistant, and vibration absorbing. Won’t unravel, peel, or degrade. Reaches into tight spaces that tape can’t. Builds up with additional coats for thicker protection.

Key Properties

Waterproof

Seals connections against water, moisture, and humidity. Ideal for outdoor wiring, marine electronics, and underground connections.

UV Resistant

Won’t crack or degrade in direct sunlight — suitable for outdoor-exposed wiring and connections.

Vibration Absorbing

The rubber coating absorbs vibration, keeping connections secure and preventing terminal screws and nuts from loosening. Effective as a thread-locking compound on electrical terminals.

Dielectric Protection

Provides strong electrical insulation at 1,200V/mil with 5–7 mils per coat. Build up additional coats for thicker insulation.

How to Use

Ensure wires and terminals are clean and dry. Stir well before use. Brush the liquid tape onto the connection area using the built-in brush cap. Allow 5 minutes to dry, then apply a second coat if greater thickness is needed. Additional coats can be applied at 5-minute intervals to build up protection as thick as required.

What It Adheres To

Metal, plastic, vinyl, rubber, and composite surfaces. Works on copper, aluminium, steel, and tinned wire. Bonds to solder joints, crimp terminals, spade connectors, and bare wire.

Applications

3D Printing & Electronics

Sealing solder joints on 3D printer mainboards and hotend wiring, insulating exposed connections on Klipper builds, protecting CAN Bus and toolhead wiring from vibration and moisture

RC & Hobby

Waterproofing ESC and receiver connections, sealing motor leads and battery connectors, protecting antenna connections

Automotive & Marine

Sealing underbonnet wiring and terminal connections, protecting marine electronics from salt and moisture, underground wiring and outdoor lighting fixtures

General

Any electrical connection where a weatherproof, vibration-resistant, permanent seal is needed

Specifications

Volume: 118 ml
Colour: Black
Type: Liquid rubber dielectric coating
Dielectric strength: 1,200V/mil
Thickness per coat: 5–7 mils
Applicator: Brush-on cap
Dry time: ~5 minutes between coats
Made in USA