Description

Eryone Hyper Speed Quadcolour Silk PLA — Four Colours, Silk Finish, Full Speed

Eryone Hyper Speed Quadcolour Silk PLA packs four vibrant silk colours into a single filament strand, producing prints with rich, flowing colour transitions and a luxurious glossy sheen. The quad-colour effect creates more complex and dynamic colour patterns than bi or tri-colour filaments — with four distinct tones blending across every print for a visual depth that single-colour silk can’t match.

Engineered for high-speed printing up to 500 mm/s, this isn’t just a pretty filament — it’s a performance material with significantly improved tensile strength over standard silk PLA, including a Z-axis tensile strength of 19.1 MPa that keeps multi-colour prints structurally sound.

Four Colours, Infinite Patterns

Each section of filament transitions between four silk colours, producing prints with complex gradient patterns that shift and blend depending on the model geometry, layer height, and where on the spool you start. No two prints are identical. The quad-colour effect is most dramatic on rounded surfaces, organic shapes, and vase-mode prints where the colour transitions have room to flow.

Silk Finish — Adjustable Brightness

The silk sheen gives prints a smooth, lustrous appearance with a polished, almost metallic glow. The brightness of the silk effect is controllable through temperature and speed — higher nozzle temperatures and slower speeds produce a more intense, glossy sheen, while lower temperatures and faster speeds give a subtler lustre. This lets you fine-tune the aesthetic to match your project.

Hyper Speed — Up to 500 mm/s

The formulation is engineered specifically for high-speed printing. Standard silk PLA often struggles at elevated speeds — weak layer bonding, inconsistent sheen, and rough surfaces. Eryone’s Hyper Speed formula maintains both the silk finish and structural integrity at speeds up to 500 mm/s, with a tensile strength of 62.7 MPa (X-Y) that puts it well above typical silk PLA.

Print Settings

Nozzle temperature: 190–220°C (higher = more glossy sheen)
Bed temperature: 55–70°C
Print speed: 30–500 mm/s (printer dependent)
Drying: 65–75°C for 12 hours before use
Enclosure: not required — open or enclosed printing

Great For

Display models and decorative pieces with a premium silk-shimmer finish
Vase-mode prints showcasing flowing quad-colour transitions
Gifts and personalised items with a luxurious appearance
Market stall products that catch the eye
Cosplay accessories and props with a metallic silk sheen
Any print where visual impact and colour complexity are the priority