Description

Basic Wood Infused PLA — Real Wood Particles, Real Wood Look

Basic Wood PLA contains approximately 15% real wood particles blended into a PLA base, producing prints with a natural matte finish that looks and feels like wood. The surface has a warm, organic texture with visible wood grain characteristics that standard PLA can’t replicate — and it smells like freshly cut wood during printing.

At $25.99 per KG on a cardboard spool, it’s an affordable entry into composite wood filament for decorative pieces, display models, and anything where you want a natural, earthy aesthetic.

Adjustable Wood Grain Effect

The appearance of wood PLA changes with nozzle temperature. Lower temperatures (190–200°C) produce a lighter, more uniform colour. Higher temperatures (210–220°C) darken the wood particles and create more contrast, simulating a deeper wood grain effect. By varying temperature between layers or across a print, you can create realistic grain patterns and colour gradients that make each print unique.

Post-Processing Like Real Wood

One of the best features of wood PLA is that it responds to finishing techniques just like real wood. Sand it smooth with standard sandpaper, stain it with wood stain for a richer tone, varnish or lacquer it for a polished finish, and paint or weather it for aged and rustic effects. A sanded and stained wood PLA print is nearly indistinguishable from a carved wooden object.

Important: Dry Before Printing

Wood PLA is significantly more hygroscopic than standard PLA — the wood particles absorb moisture aggressively. Printing with wet wood filament causes bubbling, popping, rough surfaces, and stringing. Dry thoroughly at 50°C for 6+ hours before every printing session, and store in a vacuum-sealed bag with desiccant between uses.

This is not optional. Undried wood filament will produce poor results regardless of your print settings.

Nozzle Considerations

The wood particles can accumulate inside the nozzle over time, particularly with smaller nozzle sizes. A 0.4 mm nozzle works but may experience occasional partial clogs on longer prints. A 0.6 mm nozzle significantly reduces clogging risk and is recommended for large or long-duration wood PLA prints. Avoid 0.2 mm nozzles — the wood particles will clog them.

A standard brass nozzle is fine — wood particles are not abrasive like carbon fibre.

Print Settings

Nozzle temperature: 190–220°C (lower = lighter colour, higher = darker grain)
Bed temperature: 0–60°C
Print speed: 50–200 mm/s
Diameter: 1.75 mm ±0.05 mm
Nozzle: 0.4 mm minimum, 0.6 mm recommended for reliability
Enclosure: not required
Drying: 50°C for 6+ hours — mandatory before printing

Great For

Decorative bowls, vases, and home décor with a natural wood aesthetic
Display models, figurines, and tabletop terrain
Picture frames, coasters, and personalised gifts
Cosplay props that need a carved wood appearance
Architectural models with timber-look finishes
Any project where a warm, organic, non-plastic look is the goal

Filament Specifications

Print Recommendations

Drying Recommendation

Manufacturer Data Sheet